After using this option, you can run a scan again to verify that all computers are turned on or not, turned on Computers shown with green icon with status “on” as we said above. Turning on Remote Computers on your networkĪfter the first scan, run the program and select desired Computers and then choose “Wake up Selected Computer” option (F8). Later when your Computers are turned off or in stand by mode, you can use this list to turn on all computers with a single click and here is how. On WakeMeOnLan program window turned on Computers will be shown with Status “On” with “green” icon and turned off Computers shown with status “Off” “red” icon. You can do multiple scans with this tool and this tool automatically adds new Computers if found to the list, meanwhile you can also remove obsolete Computers from the list also by using “Delete selected items” option. You can stop scanning at any moment by pressing F6 if you found tool scanning wrong IP address range, you can then go to “Advanced Options “ window (F9 ) and choose correct IP address range for the scan. Once your Computers are turned on and running, click Start scanning (F5) from file menu and this tool collects MAC addresses/Computer names/IP addresses of all your Computer and stores this list to a configuration file ( WakeMeOnLan.cfg). #EMCO WAKEONLAN SETUP ARCHIVE#Select “Power Management” tab and select “allow this device to wake the Computer” and also select “Only allow a magic packet to wake the Computer”, click OK to save changes.ĭownload and extract program archive to a folder and run WakeMeOnLan executable. Open Device Manager, right-click on Network adapterĢ. To enable Wake-On-Lan feature for a Computerġ. You can enable Wake-On-Lan feature on some Computers on the BIOS setup. For this feature to work, your Computers should support and have this feature enabled. Wake-On-Lan feature works only for computers on wired network not for wireless networks. Wake-On-Lan feature must be turned on Remote Computers This tool also lets you turn on a Computer from a command-line by specifying Computer Name, IP Address, or MAC address of the remote Computer. It does this by sending Wake-On-Lan packet to remote computers. #EMCO WAKEONLAN SETUP PORTABLE#WakeMeOnLan is freeware portable tool lets you turn on Computers remotely on your wired network with a single click.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |